7
www.combisteel.com
2.1.1 Unpacking
The two-arm mixer comes wrapped in a sticky plastic layer (retractile film), which stops dirt and dust from getting
inside during transport. It is then tied to the palette with GREEN NYLON strapping and WOODEN BOARDS which
impede any movement of the machine inside the packaging. Finally, it is then placed inside a wooden cage
specially designed for its transport.
Unpacking should be carried out in the following manner:
•
Place the packaged machine totally flat on the floor.
•
Remove the nails which hold down the lower part of the cage with the packaging pallet.
•
Lift the top part of the cage with the help of a forklift truck or a rolling crane.
•
Cut the GREEN NYLON strapping and remove the boards, the machine can be removed from the pallet.
•
Remove the retractile film covering.
•
Place the slings over the head of the bedplate of the machine and lower it onto the floor.
2.1.2 Site
The machine should be placed in a light, accessible place, where the operator can move freely with no difficulties.
2.2 Condition of Use
The machine is manufactured to be used inside. It is not designed to work outside. It must be protected from
falling water.
ATTENTION!
Machine storage: -25
°C to +50°C
Ambient temperature during operation: +4°C to +40°C.
This machine is for professional use and must be used by staff trained to use, clean,
and maintain it, in terms or reliability and safety.
Use the machine in adequately lit premises (See applicable technical standard for the
country of use. In Europe, refer to standard EN 12464-1)
When handling the machine, always check that the parts taken hold of are not mobile
elements: risk of dropping and injury to the lower limbs.
The machine is not designed for use in explosive atmospheres.
