6
www.combisteel.com
1. Warning
Read this instruction manual before switching the machine on. Keep this instruction book together with the
appliance for future consultation.
These warnings were drafted for your safety and for that of others. Please read them carefully before installing
or using the appliance.
The appliance is intended for professional use and must be utilized by qualified personnel trained to use it.
Any modification which may be necessary on the electrical system to enable installation of the appliance, must
be carried out solely by competent personnel.
It is dangerous to modify or attempt to modify the characteristics of this appliance. Starting up. This unit must
be grounded for your protection to avoid the risk of electrical discharges. It should be connected directly to the
ground terminal of the control cabinet. The ground cable must not be cut or disconnected from the machine.
The introduction of an object or foreign body other than that necessary in the manufacture of the dough is totally
forbidden.
Before doing any maintenance or cleaning jobs, disconnect the appliance from the electrical mains and allow it
to cool. The acoustic power emitted by the machine is lower than 70 dB.
NOTE
: The manufacturer will not be held responsible for the following:
•
Incorrect installation of the machine
•
Use of non-original spare parts
•
Electrical supply problems
•
Non authorized alterations
•
Lack of daily maintenance
•
Improper and/or incorrect use of the machine
•
Non-compliant use according to current regulations in the country where the machine will be installed.
2. Preassembly Instructions
2.1 Storage and Transport
The machine has been sent completely assembled and packaged on a wooden platform with a plastic wrapping
to protect the appliance from possible sporadic exposure to rain.
The machine must be transported in a completely closed vehicle with platform and must not be left outside.
In any case, the operations to package and secure the different accessories to the machine must be carried out
before transporting and moving.
PAY ATTENTION AT ALL TIMES WHEN UNLOADING THE MACHINE AS THE PACKAGING AND THE MACHINE ITSELF
COULD BE DAMAGED.
Unloading the two-arm mixer from the truck or method of transport used, should be carried out with the help
of a forklift truck, a rolling crane or derrick, however if two systems are available the first system should be used.
FORKLIFT TRUCK: Place the truck forks below the packaging pallet, as far in as possible. Lift the forks gently and
place the packaged machine onto the floor, then unpack. If the forks from the truck appear not to go in far
enough, then another unloading method should be considered.
ROLLING CRANE: Pass the slings underneath the two-arm mixer packaging; insert the sling handles onto the
crane hook, ensuring it is well supported so that it does not fall. Then place the machine onto the floor and
unpack. Bear in mind the center of gravity of the machine is situated near the main body of the machine.
