NEED TO CONTACT US?
www.winstonindustries.com | E-mail [email protected]
Phone 1.800.234.5286 | 1.502.495.5400 | 1.502.495.5458 • Mail 2345 Carton Drive | Louisville, KY 40299 USA
17
FRYERS
DAILY CARE (CONTINUED)
8.
!
CAUTION:
Wearing safety gloves, remove collector with basket drain hook
placed in collector lifter loop (Figure 20).
9.
Remove and Clean Collector Gasket
Note: Gasket life may be prolonged by doing the following:
•
Keep spare set to alternate nightly. Lubricate with clean cooking oil before
using.
•
Clean gaskets after daily use and store in a container of water in cooler.
•
Do not stretch gasket more than necessary to place on collector. Discard
gasket if cracked or breaking.
•
Never strike cookpot or collector with spatula or other tools. Gaskets may be damaged
on sharp, rough edges that result from such striking.
10.
!
DANGER:
Do not use “boil out” method of cleaning fryer or fill fryer with
any liquid other than cooking oil. Fryer is made to be pressurized only with cooking oils. If
pressurized with other liquids, you may be burned, badly hurt, or killed.
11.
Scrub Heater Coils
with white teflon brush. Clean heaters, heater holders, and all of
cookpot (Figure 21). Do not use steel wool.
12.
Rinse
inside of cookpot with cooking oil only.
13.
Wash Accessories
(using hot water only) including collector (clean gasket groove), gasket,
heat plate, utensils, basket, etc., at sink. Wipe dry.
14.
!
DANGER:
Don’t splash water on outside of fryer or wash outside of fryer
with hose. If you do, you may get water into hot cooking oil, causing it to boil over, or you
may get electrical components wet, causing a short circuit. Clean outside of fryer with
damp towel (do not use steel wool) and wipe dry.
For Pressure Fryer Models Only:
15.
!
CAUTION:
Muffler (on PF Models) may be hot from steam condensation.
Wear safety gloves. Remove muffler (Figure 22), empty and wash in sink.
16a. For PF Models:
Clean Vent Components
Remove deadweight and wipe out vent block
(Figure 23). Clean deadweight at sink, towel dry and place back in vent assembly.
16b. For LP Models: remove deadweight from main vent assembly on rear of fryer by lifting tube.
Deadweight is under tube. (See Figure 24). Rinse deadweight and tube (inside and out) with
hot water at sink. Towel dry. Reassemble Deadweight and tube. Check O ring where vent
tube connects.
FIGURE 20
FIGURE 21
FIGURE 22
Vent
Back
FIGURE 23 (PF Models)
Deadweight
Tube
FIGURE 24 (LP Models)