TM
21
6.2 Calibrate Mode
Note: If the calibration standard condition is not met, platform level must
be adjusted.
6.2.3.2 Calibration Standard Condition:
The test sheet must be lay down flat in the platform,
and the test sheet must be touching the nozzle tip.
Condition 1: There is a gap between the nozzle tip and the test sheet.
Adjustment 1: Rotate the butterfly nut under the platform counterclockwise
until the test sheet just touch the nozzle tip as standard
condition.
Condition 2: The test sheet is over the nozzle tip.
Adjustment 2: Rotate the butterfly nut under the platform clockwise until
the test sheet can just touch the nozzle tip as standard condition.
Nozzle
Platform/Heat Table
Test Sheet
