22
•
Press
key to confirm. Message
<LoAd>
is displayed for 1 s. Next, the following
window is displayed:
•
If the parts are to be weighed in a container, first put it on a weighing pan and next tare it.
•
Load the weighing pan with declared amount of parts. When the indication is stable (
pictorgram is displayed) press
key to confirm the mass.
•
Mass of a single part is automatically calculated and next quantity of parts (pcs) is
displayed:
Remember:
•
Maximum mass of all parts on the weighing pan cannot be greater than maximum
capacity.
•
Mass of a single part has to be equal or greater than
0.1 reading unit
of the balance. If
the abovementioned condition is not fulfilled, message
<Err Lo>
is displayed.
•
During parts counting determination wait until
pictogram is displayed. Next, confirm
declared quantity of parts.
7.8 . +/- CONTROL
+/- control working mode enables entering checkweighing thresholds values (
Min
,
Max
).
7.8.1 SETTINGS
•
Accessibility of
<HiLo>
(+/- Control) mode is declared within
<P3.3.1Acc>,
procedure found
within section 7.2
•
Method of sending data to peripheral device is declared within
<3.3.2.Snn>
, procedure found
within section 7.3.
•
Method of setting automatic printout time for sending data to peripheral device is declared
within
<3.3.3.Snn>
, procedure found within section 7.4.
•
Method of setting lo threshold value for automatic operation is declared within
<3.3.4.Lo>
,
procedure found within section 7.5.
7.8.2 DECLARING CHECKWEIGHING THRESHOLDS
Procedure:
•
To enter menu navigation, follow process found in Section 3.2 (page 7). Enter
“+/-
control” <HiLo>
working mode.
•
Message
<SEt Lo>
is displayed for 1s. Next, a message box for entering low threshold
(Min) value is displayed.
