High-Speed Outputs
The I/O module provides two high-speed discrete outputs (HS OUT 0 and HS OUT 1) that can be used to trigger remote
events to the In-Sight Micro and In-Sight 5000 series vision systems. High-speed output signals travel through the I/O
module without processing. The outputs are typically connected (directly or indirectly) to a load (such as a relay, indicator
light or a motor). Refer to
for common wiring configurations.
Note
: The I/O module does not provide access to the In-Sight 7000 series vision system's high-speed outputs. The
In-Sight 7000 series vision system's high-speed outputs are only accessible from the vision system's Breakout
cable.
CAUTION
:
When connecting the In-Sight 7000 series vision system to the CIO-MICRO or CIO-MICRO-CC I/O
module, the I/O module's HS OUT 0, HS OUT 1 and HS COMMON terminals are not supported. Do not connect wire
leads from remote devices to these terminals.
In-Sight Micro Vision Systems
The In-Sight Micro vision system features two built-in, high-speed outputs, which are optically isolated. The high-speed
outputs can be used as either NPN (current sinking) or PNP (current sourcing) lines.
Specification
Description
Voltage
28VDC maximum through external load.
Current
100mA maximum sink current.
OFF state leakage current 100µA maximum.
External load resistance 240 Ohms to 10 kOhms.
Each line rated at a maximum 100mA, protected against over-current, short circuit and transients from
switching inductive loads. High current inductive loads require an external protection diode.
Delay
12
5µs (maximum due to opto-isolators turning ON).
CAUTION
:
l
Do not connect a high-speed output to OUT COMMON. High-speed outputs use HS COMMON as a return
path.
l
Since both high-speed outputs share a common return (HS COMMON), when both HS OUT 0 and HS OUT
1 are used, both must be current sinking or current sourcing. Do not mix current sinking and current sourcing
on high-speed outputs.
1
Delay when opto-isolators turn OFF depends on the load to which the output is connected. With a 240 Ohm load, the maximum delay will be
35µs.
2
If HS OUT 1 is configured as a Strobe output type within In-Sight Explorer, the maximum strobe latency is 5µs. For more information, refer to
the
In-Sight
®
Explorer Help
file.
31
Specifications
