Chapter 1: Setting up Your In-Sight 1010
9
Connecting to a Relay
Connect the outputs to one side of the relay coil. Connect the other end of the coil to 24V.
•
Pass – Coil Activated.
•
Fail – Coil De-activated.
The active state of the Job Completed output pulse is ‘coil activated’.
Serial Output
The code read by the In-Sight 1010 is transmitted on the system’s RS232 serial port. The
default port settings are:
•
Baud rate 9600.
•
8 data bits.
•
1 stop bit.
•
No parity.
•
No Handshaking.
When reading
one
code the output stream will be:
<ASCII data><CR>
When reading
two
codes the output stream will be:
<code1 ASCII data><delimiter>< code2 ASCII data<CR>
The delimiter is a comma (,) by default; this can be changed using the
Communications
wizard.
Reporting the Code Over the Network
The code read can also be transmitted over the network to a specific device. The name of the
device receiving the code and the communication channel number needs to be specified.
These settings (and more detailed help) are found in the
Communications
wizard.
