Cognex DS900 Series, Reference Information

Page: 4 / 42

Precautions
Observe these precautions when installing the Cognex product, to reduce the risk of injury or equipment damage:
l
To reduce the risk of damage or malfunction due to over-voltage, line noise, electrostatic discharge (ESD), power
surges, or other irregularities in the power supply, route all cables and wires away from high-voltage power
sources.
l
Changes or modifications not expressly approved by the party responsible for regulatory compliance could void
the user’s authority to operate the equipment.
l
Cable shielding can be degraded or cables can be damaged or wear out more quickly if a service loop or bend
radius is tighter than 10X the cable diameter. The bend radius must begin at least six inches from the connector.
l
This device is a business-use (Class A) EMC-compliant device. The seller and user are advised to be aware of
this fact. This device is intended for use in areas outside the home.
l
This device should be used in accordance with the instructions in this manual.
l
All specifications are for reference purpose only and may be changed without notice.
Laser Models
The following sensors contain a class 2M laser:
Model Class 2M Laser
DS910B (820-9166-1R)
DS925B (820-9164-1R)
√
Laser Safety Warnings
LASER LIGHT, DO NOT STARE INTO BEAM: CLASS 2M LASER PRODUCT
FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE SERIOUS INJURY
Cognex places the following labels on every 3D displacement sensor:
DS925B
DS910B
4
Precautions