Coemar Infinity Wash M, Instruction Manual

Page: 22 / 29

English
22
WARNING !
• after the installation of this lamp and each time you replace it, we recommend the following operations.
• realign the lamp in the optical system in order to avoid dichroic filters overheating and consequent effects.
• reset the lamp odometer to obtain reliable information about the residual life of the lamp.
9.4 Turning back to discharge lamp (700W or 575W)
This is a very important chapter if you are going to replace the halogen lamp for the 700W (OEM configuration) or 575 W lamp. Please
read it carefully and ensure you have understood the topics.
The transition from discharge lamp (700 or 575W) to halogen lamp requires no settings, in fact the equipment recognizes the type of lamp and set
automatically. The reverse operation ( halogen to 700/575W) requires that the projector’s setting matches the type of lamp we are going to install;
for example, if your Infinity M was set to work with 700W lamp before the transition to halogen, you are going to install a 575W lamp and you forget
to set Infinity M, when you’ll turn the lamp on, the projector will be damaged. Follow these hints to change the lamp safely:
1 Install the discharge lamp.
2 Turn on Infinity M keeping pressed MENU ENTER e “+” and follow the instruction to change the lamp setting..
3 Turn on again the projector and look at the display, Infinity M will delay the turning on of the lamp to give you the opportunity to check the type of
lamp set .
The system warns you that Infinity M has been set to work with 700 W
metal halide discharge lamp
.
The system warns you that Infinity M has been set to work with 575 W
metal halide discharge lamp
.
4 Check that the setting matches the lamp you’ve installed; if it doesn’t match, turn off immediately the unit and repeat the procedure described
above.
5 Once made the correct setting, turn on Infinity M, turn on the lamp and don’t forget to adjust it.
Dimmer mode explanation
Halogen dimmer curve channel
(see DMX chart above) Dimmer/shutter status Lamp status time
Mechanical dimmer works in sync with the
dimming of the lamp
Dimmer closed
Minimum power 0 seconds
off 5 minutes
Shutter closed
Minimum power 10 seconds
off 5 minutes
Mechanical dimmer has no effect and is active
only that the halogen lamp (variable color
temperature)
Dimmer closed off 0 seconds
Shutter closed
Minimum power 10 seconds
off 5 minutes
Black-out of the light beam during PAN/TILT
movement, gobos wheel, colors wheel and effect
wheel.
Dimmer closed
Minimum power 10 seconds
off 5 minutes
Shutter closed
Minimum power 10 seconds
off 5 minutes
.>>> WARNING:<<<
Current MH lamp
setting is 700 W
PLEASE CHECK
CORRECT SETTING
.>>> WARNING:<<<
Current MH lamp
setting is 575W
PLEASE CHECK
CORRECT SETTING