English
17
8.4 Measures
The internal microprocessor of the Infinity Wash M allows for several diagnostic and output parameters to be displayed.
8.5 Display setup
The display setup allows tot une the
Infinity Wash M
functions according to your needs. The following diagram shows the section features.
DISPLAY SETUP
DISPLAY REVERSE
BACKGROUND
COLOR
DISPLAY TIME OUT
BUTTON TIME OUT
BRIGHTNESS
-Standard
-Reverse
-Standard
-Reverse
-OFF
-
# secs.
(+/-)
-OFF
-
# secs.
(+/-)
1~100%
(+/-)
It allows 180° rotation of the display graphics in case of
upside-down installation of the fixture.
It allows visualization in negative or in positive of the display
graphics.
It allows one to decide number of seconds before turning off
the display back light in case of inactivity. OFF value leaves
the backlight always on.
It allows setting up number of seconds buttons must be
pressed in order to activate functions. This function avoid
activation of features if buttons are pressed accidentally.
It allows setting of brightness of display back light..
MEASURES
It shows the temperatures detected by the sensors in the base:
Tdriver, Tsens#1, Tsens#2, Tsens#3.
It measures main power voltage of the fans:
vmain, vboard, vfan1, vfan2, vfan3.
Values over 28.5 V must be
considerated as abnormal.
Reading of the DMX value (0-255) received from each channel used by
the fixture on the DMX 512 line.
Reading of the typical value of the DMX signal called “RATE” (signal
update frequency in milliseconds).
It shows possible ongoing alarm messages.
It shows lamp’s status on or with “zap effect” enabled.
It shows fixture’s odometers:
lamp life (r):
lif e of the lamp (resettable),
lamp life
: total life ao the lamps installed (not resettable),
unit life
:
fixture’s life.
It shows the actual installed software version:
sw LCD master
: software installed on to LCD master board.
sw MOTOR slave
: software installed on to MOTOR slave board .
TEMPERATURE
VOLTAGE
DMX INPUT MEASURE
DMX RATE
ALARM STATUS
LAMP STATUS
USAGE HOURS
SOFTWARE VERSION
BALLAST MEASURES
It shows the operating information of the ballast:
Lamp type
: installed lamp type (575 o 700 W).
Actual power
: Instant power in W emitted from the ballast.
T1max, T2max
: Max temperatures (resettable) detected by the ballast.
NStsk
: lamp’s strike attempts with countdown.
Summary of Contents for Infinity Wash M
Page 1: ...Infinity Wash M instruction manual manuale di istruzioni Version 0 DIS128 ...
Page 2: ......
Page 4: ......
