English
21
9.2 Aligning the lamp in the optical path
Aligning the lamp in the optical system is achieved via the 3 adjusters at the rear of the projector. This procedure should be undertaken to maximize
output, to avoid the possible overheating of the internal components due to the incorrect focusing of the beam onto components not predisposed to
high temperature. It is extremely important to obtain a uniform distribution of light on all beams.
Alignment procedure
Alignment is carried out by using the 3 screws A, B and C showed in the picture below. The lamp should be on, black-out and dimmer fully open,
and no colours selected. If the lamp is not correctly aligned, a hot-spot to the most central part of the beam possible and then flatten the beam to
maximum uniformity. The combined regulation of the three adjusters allows horizontal, vertical and axial regulation of the lamp.
9.3 Halogen lamp operations
Previous to install the lamp, you should ensure that your Infinity M has the software required to manage the new features.
Keep pressed, while turning on the unit, “+” and “-“ keys, the display shows a screen like this:
Version configuration
Situation
Action
A
The halogen lamp cannot be
installed because the ballast is not
suitable. (SW ballast version must
be successive to 1.70)
Replace the ballast with kit
BC10013B002 and upgrade
LCD and MOT software.
B
The ballast is suitable for the
halogen lamp but it is
recommendable update the ballast
software to version 3.70
Update ballast software using
DR1+.
In order to upgrade the software on your Infinity M, DR1+ device is strictly required.
Provide yourself with this product if you do not have it. After you have installed DR1 + Lite Interface on your PC and you have correctly connected
PC, DR1+ device to Infinity M (remember that in the case you are using a laptop PC you should drive USB patch trough a self-powered USB Hub),
you are ready to perform the software installation on Infinity M that can vary regarding the two cases mentioned in the previous chapter:
Case “A”:
You’ll have to replace the ballast with KIT BC10013B002; this one will come with the correct hardware and software version (3.70), then
you’ll have to upgrade LCD and MOTORS software to LCD 2.13 and MOTORS 2.09. These software versions are available in the CD included in
this kit. Refer to DR1+ user manual to learn how to perform the software upgrade.
Case “B”:
You’ll have to upgrade the ballast software to 3.70. This operation is slightly different respect LCD and MOTOR software upgrade.
1-Go with the mouse on the fixture you have to upgrade in the left column of DR1+ Lite Interface.
2-Keep pressed ALT+CTRL+SHIFT and click the right button of the mouse; a pop up menu will appear.
3-Keeping pressed ALT+CTRL+SHIFT Click on SEND COMMAND-SERVICE MENU-SHOW BALLAST. In the list you should now see the ballast
device you are going to upload the software on.
4-Upgrade the software ( you’ll find the 3.70 file in the CD ROM included) in the same way you did for LCD or MOT.
5-In order to return to fixtures list, repeat the operation in step 3 clicking HIDE BALLAST instead of SHOW BALLAST.
6- Check that software versions are updated LCD at 2.12 and MOT 2.09
INFINITY __M
-SW LCD: 2.10.00
-SW MOTORS: 2.04.00
-LDR LCD: 1.40
-LDR MOTORS: 1.40
-SW BALLAST: 1.70
INFINITY __M
-SW LCD: 2.12.00
-SW MOTORS: 2.08.00
-LDR LCD: 1.40
-LDR MOTORS: 1.40
-SW BALLAST: 1.80
Summary of Contents for Infinity Wash M
Page 1: ...Infinity Wash M instruction manual manuale di istruzioni Version 0 DIS128 ...
Page 2: ......
Page 4: ......
