English
11
7. Turning on the projector
After having followed the preceding steps, proceed with the power supply and turn on the projector via the main power switch.
The display will show a short welcome message and the software version installed on the internal microprocessors:
The projector will perform the reset function on all motors. This operation will last a few seconds, thus allowing the digital control motors to correctly
position themselves. Then the display will turn on in a fixed mode, indicating the correct DMX 512 signal reception.
During the reset function the display will blink for a few seconds…. …then the DMX address of the projector will appear
If the address continues to blink and the “NO DMX SIGNAL” message appears, it means that the DMX signal has not been received. Check the
connection cable and the mixer functioning.
7.1 DMX address of the projector
NB: The following section is valid only in the case where Infinity Spot XL is controlled by the signal DMX 512.
Each projector utilises 18 address channels (16 bit) for its complete operation and is controlled by a DMX 512 signal (for further information, see
section 7.2, DMX functions).
When powered up initially, each projector will show A001, which indicates DMX address 001; a projector thus addressed will respond to commands
of channel 1 to 18 from your DMX 512 controller. A second unit must be addressed as A019, a third as A039 and so on. The operation must be
carried out every Infinity Wash M which has an address different from A001.
Altering DMX address
1.
Press the + or – button until the display shows the required DMX address. The digits on the display will blink to indicate that the variation has not
been registered.
2
. Press the
enter
key to confirm your selection. The digits on the display panel will cease to blink and the projector will now respond to the new
address.
NB: by holding the + or – button down the scrolling will be faster; thus allowing a faster selection
WARNING!
If you alter the DMX address with no DMX signal connected, the digits on the display panel will continue to flash
even after you have pressed ENTER button to confirm the address.
Summary of Contents for Infinity Wash M
Page 1: ...Infinity Wash M instruction manual manuale di istruzioni Version 0 DIS128 ...
Page 2: ......
Page 4: ......
