Congratulations on having purchased a
coemar
product. You are assured of a projector of the highest quality, both in the
componentry used and in the technology. We reiterate our invitation for you to complete the information on the previous page
to expedite any request for service information or spares (in case of problems encountered either during, or subsequent to,
installation). This information will assist in providing prompt and accurate advice from your
coemar
service centre.
Following the instructions and procedures outlined in this manual will ensure the maximum efficiency of this product for years
to come.
Open the packaging and ensure that no part of the equipment has suffered damage in transit. In case of damage to the equip-
ment, contact your carrier immediately by telephone or fax, following this with formal notification in writing.
packing list
Ensure the packaging contains:
1
Fiera
575 EB
1 instruction manual
2 U-shaped cam-locking suspension devices
2 additional lenses
1 envelope containing 2 fuses suitable for respective voltages.
The
Fiera
575 EB
should be transported in its original packaging or in a
coemar
approved flight case.
During transportation, the packaging should ensure that the articulated movement of the
Fiera
575 EB
should be blocked.
Fire prevention:
1.
Fiera
575 EB
utilises a Philips 575 MSD, 575 MSR or 575 MSR/2 lamp; the use of any other lamp is not recommended
and will null and void the fixture’s warranty.
2.
Never locate the fixture on any flammable surface.
3.
The minimum distance from any flammable materials: 0,5 m.
4.
The minimum distance from the closest illuminable surface: 2 m.
5.
Replace any blown or damaged fuses only with those of an identical value. Refer to the schematic diagram if there is any
doubt.
6.
Connect the projector to the mains power via a thermal-magnetic circuit breaker.
Preventing electric shock:
1.
High voltage is present in the internals of the unit. Isolate the projector from mains supply prior to performing any function
which involves touching the internals of the unit, including lamp replacement.
2.
For mains connection, adhere strictly to the guidelines outlined in section 7 of this manual.
3.
The level of technology inherent in the
Fiera
575 EB
necessitates the use of specialist personnel for all service applica-
tions; refer all work to your authorised
coemar
service centre.
4.
A good earth connection is essential for proper functioning of the projector.
Never operate the unit without proper earth connection.
5.
Do not locate the fixture in an exposed position, or in areas of extreme humidity. A steady supply of circulating air is essen-
tial.
Protection against ultraviolet radiation:
1.
Never turn on the lamp if any of the lenses, filters, or the housing is damaged; their respective functions will only operate effi-
ciently if they are in perfect working order.
Never look directly into the lamp when it is operating.
Safety:
1.
The projector should always be installed with bolts, clamps, and other fixings which are suitably rated to support the weight of
the unit.
2.
Always use a secondary safety chain of a suitable rating to sustain the weight of the unit in case of the failure of the primary
fixing point.
3.
The external surfaces of the unit at various points may exceed 150°C. Never handle the unit until at least 10 minutes have ela-
psed since the lamp was turned off.
4.
Always replace the lamp if any physical damage is evident.
5.
Never install the fixture in an enclosed area lacking sufficient air flow; the ambient temperature should not exceed 35°C.
6.
A hot lamp may explode. Always wait for at least 10 minutes to elapse after the unit has been turned off prior to attempting to
replace the lamp.
Always wear suitable hand protection when handling lamps.
Protection rating against penetration by solids and liquids:
1.
The projector is rated as an ordinary device. Its protection rating is IP 20
3. Important safety information
2. Transportation
1. Packaging
25
English
