If the operating voltage set by
coemar
does not correspond to that is use in your country of operation, or if the projectors are
destined for use in another country, a new operating voltage selection may be made as described below.
Incorrect frequency and voltage selection will detrimentally affect the operation of the projector and immediately void the warranty.
17.1. Selecting transformer operating voltage
This selection will alter the operating voltage to the electronic pcbs and internal motors.
1) Remove the screws on the base housing using a Philips head screwdriver as shown in the diagram below; completely
remove the cover, thus providing full access to the internal components in the base of the
Fiera
575 EB
.
1) Locate the transformer in the base of the unit.
2) Select the voltage from amongst 100, 115, 200/208, 230 or
240V by removing cable n° 5 and moving it to the required vol-
tage. Refer to the sticker on the transformer to ensure you are
selecting the correct voltage.
Cables numbered 7 and 3 should under no circumstances be
moved from their respective positions.
3) If your operating voltage is set at 100 or 115V, replace the 5
A m p T f u s e a n d t h e 1 A m p T f u s e , b o t h i n t e n d e d f o r
200/208/230/240 V operation, with respective fuses of 10
Amp T and 2 Amp T.
The fuses are located in the fuseholders in the base of the
projector as shown in the diagram.
If your operating voltage is set to
200/208/230/240V, replace the 10
Amp T, and the 2 Amp T, suitable
for 100/115 V operation, with
fuses of 5 Amp T and 1 Amp T
respectively.
New fuses are located in the
packet which came in the original
packaging, alongside this
manual.
4) Replace the base cover and re-affix all screws as per their original positions.
5) Make a clear note of the new operating voltage on the outside of the base of the
Fiera
575 EB
.
factory set
main at:
100V
115V
200/208V
230V
240V
50Hz
60Hz
T1A @230V
T2A @115V
T5A @230V
T10A @115V
17. Altering the operating voltage
(Reserved for technical staff)
38
English
