Victory 3_en.pdf http://en.codelight.com.cn
30
7.6.3.
Snap Percentage
The
[Snap Percent]
allows you to control when instant channels should occur. It defaults in 0%.
If the snap percent is 0% the channel occurs at the beginning of the cue fades in.
If the snap percent is 100% the channel occurs at the end of the cue.
If the snap percent is 50% the channel occurs in the middle of the cue.
7.6.4.
Time for Cue-lists in Chase mode
Global and attribute times are unavailable for Cue-lists in chase mode. The time for chase mode can
only be set by using Wheel D, while the
‘Cross’
is set by using the
Shift
key with Wheel D.
Cross=100% means steps will use the time to fade in the next step.
Cross=0% means steps will not have a fade in time. The time is used as delay in for each
step.
Speed=2.0s means every step in the chase runs in 2.0 seconds.
7.6.5.
Manually control Speed of Cue-lists
After faded in a cue-list, you can use Wheel D to adjust the speed directly. If you need to adjust other Cue-lists speed,
then you have to hold
Shift
and press the needed playback key to set the Cue-lists at current:
Roll the Wheel D to set the speed percentage of the Cue-lists, on the bottom right corner will display as:
‘Speed=100%’
(range at 10
～
500%).
Press the speed frame to make it turns red, then press Wheel D to make it turn green (it is the start mark
of setting speed). Press Wheel D again and the frame turn red again (it is the end mark of setting speed). Then
the system will calculate a speed by the time slot between the start mark and end mark (range at 10
～
500%).
Press the speed frame again to quit setting.
7.7.
Playback Parameters and Advanced Settings
There are many options for you to edit playback parameters for each playback in
‘Playback Edit Menu’
. You may
also find the settings by pressing
[Playback Parameters]
and then select the playback number.
Besides, hold down the
SHIFT
key and select the playback name on touch screen can also call out the parameter
setting menu.
