![background image](http://html.mh-extra.com/html/cobra/spyball-6808-9/spyball-6808-9_user-instructions_2630292029.webp)
___________________________________________________________________________________________________
SPYBALL 6808-9/6828-9 29
1.
While the system is disarmed, turn ignition on.
20 seconds later the LED lights up and remains on for
3 seconds.
2.
During this lapse of time, press push-button n. 1 of the transmitter.
A sharp audible signal confirms
you have entered the
procedure of adjustment of the sensitivity to displacement
(e.g. towing / lifting).
3.
Press push-button n. 1 to increase sensitivity.
A short sharp audible signal confirms the success of the
operation.
Press push-button n. 2 to decrease sensitivity.
A short deep audible signal confirms the success of the
operation.
The minimum and the maximum sensitivity levels are signalled by 3 audible signals in sequence.
4.
Once the appropriate sensitivity level has been selected, turn ignition off, then turn it on immediately
again.
A deep audible signal confirms you have entered the
procedure of adjustment of the
sensitivity to shock.
5.
Operate as described at pos. 3).
6.
Once the appropriate sensitivity level has been selected, turn ignition off.
A sharp audible signal
confirms you have quit the selection procedure.
To test the movement sensor and determine the optimal sensitivity level more easily, you can simulate
displacement / shock before quitting the procedure; if the sensitivity is sufficient to trigger the unit, you will get
a sharp audible signal (instead of a full alarm cycle).
Remarks:
To ensure accurate adjustment, avoid generating shocks while selecting the level of sensitivity to
displacement.
It is recommended to evaluate the optimal sensitivity levels once both adjustments have been set, before
quitting the procedure.