![background image](http://html1.mh-extra.com/html/cobra/cx50p3/cx50p3_manual_2630605013.webp)
13
Fill the syringe half full with brake fluid.
Remove the brake caliper bleed screw.
Attach the syringe to the brake caliper bleed access. Keep the syringe
oriented as not to allow air from the syringe into the system.
Using the syringe pull fluid through the system. Use caution not to let the
fluid in the reservoir to become low and introduce air into the system.
Using the syringe push fluid back into the system until the reservoir is full.
Repeat these actions of pulling and pushing fluid through the system a few
times.
With the reservoir full, engage the brake lever/pedal and hold it there as if
engaging the brakes.
While doing this pull on the plunger of the syringe. Doing this will cause a
vacuum in the system. The vacuum will swell the air bubbles which assist
in them moving throughout the system.
Continue pulling a vacuum and release the brake lever/pedal (careful not
to allow the reservoir to become empty).
Once again engage the brakes while continuing to pull a vacuum.
When the reservoir is almost empty stop and push fluid back into the
system.
Repeat these steps with the vacuum until no more air bubbles can be
removed from the system.
Remove the syringe. Be sure to keep the caliper below the level of the
reservoir to allow the fluid to run out of the caliper and not allowing air into
the system.
Reinstall the bleed screw, being sure that the ring is in place.
Fill the reservoir with fluid (the fluid should be full enough that the fluid
spills out when placing the lid on) and replace the cover.
Air Filter Cleaning
Tools recommended for air filter maintenance:
#2 Phillips head screwdriver
4 mm Allen wrench
Foam
filter
oil
Summary of Contents for CX50P3
