![background image](http://html1.mh-extra.com/html/cobra/2007-king-50/2007-king-50_service-manual_2630597013.webp)
3.
The frame is 4130 Chrome Moly and it is important to weld it with the proper
rod and heat settings set as light as possible. Cobra recommends replacing
the frame with a new one if the old one becomes damaged. Use ER70S6
filler if welding on the frame.
4.
If your kick-starter lever does not return properly, first try loosening the six
kick/clutch cover screws ½ turn. Hold the kick lever ½ way down while
retightening the six screws starting for the center and working out.
5.
Inspect CFD slip torque every 10 hours of riding or replace the friction
papers and the load spring (Bellville spring) every 20 hours.
6.
Check proper clutch engagement before and after each ride. If the clutch is
engaging properly DO NOT feel the need to take the clutch apart to;
measure the spring stack, clean the stack, replace the springs, etc... Cobra
has worked real hard to make a clutch that is low maintenance and so only
take it apart if it NEEDS to be maintained.
Replacing Transmission / Clutch Lubricant
Tools needed:
•
235 ml (8.0 oz)
Cobra Venom 3 Shoe Clutch Milk
(Part # MCMUGF01).
Procedure:
1. Begin this procedure with a bike that has been ridden more than 5 minutes
but less than 10 minutes. It is desired to have the engine warm enough so
that the oil is ‘runny’ but not so hot that there is risk of being burned by the
engine or the oil.
Hot oil and hot components on the motorcycle may cause burns.
2. Lean bike against something or set on stand with oil drain hole.
3. Remove the oil drain plug located on the right side of the engine, on the
clutch cover, near the brake lever (figure 1).
12