![background image](http://html1.mh-extra.com/html/cobra/2007-king-50/2007-king-50_service-manual_2630597045.webp)
8 0.8 0.031
ZCMU0708
ZCMU0012
9 0.9 0.035
ZCMU0709
ZCMU0015
1 1.0 0.039
ZCMU0710
ZCMU0016
NOTE
Tolerances will affect the actual gasket thickness’.
If during the course of the maintenance more parts than the base gasket are
changed, the squish clearance should be measured, and possibly a different
base gasket will be required.
The easiest way to measure squish clearance is with 1mm to 1.5mm thick
flexible solder wire (available through most popular electronic stores). The
process is as follows:
•
Assemble the engine without a base gasket to the proper torque
specifications leaving off the spark plug and ignition cover (piston rings can
be left off to ease assembly).
•
Carefully insert the solder wire though the spark plug hole, into the cylinder
far enough such that the tip of the wire touches the cylinder wall against one
side or the other (not the front or back as the piston will rock and give
incorrect measurement).
•
Hold the wire at this position and turn the crankshaft, by the flywheel nut,
clockwise (counter clockwise can loosen the flywheel nut) one revolution to
‘smush’ the solder wire.
•
Pull out the wire and measure the solder thickness, approximately 2mm from
the end of the tip, accurately with calipers.
•
Compare your measurement with the chart below and install the
recommended base gasket.
Measured Solder
Thickness With
NO GASKET
Required Gasket
Thickness
Cobra Part Number
(mm)
(inch)
(mm)
With silicone bead
Without
silicone bead
* * *
*
*
*
0 0 0.81 0.032 ZCMU0708
ZCMU0012
0.1 0.004 0.71
0.028
ZCMU0707
0.2 0.008 0.61
0.024
ZCMU0706
0.3 0.012 0.51
0.020 ZCKG0501
(new)
ZCKG0501
(old)
0.4 0.015 0.41
0.016
ZCMU0704
0.5 0.020 0.31
0.012
ZCMU0703
0.55 0.022 0.26
0.010
ZCMU0011
0.6 0.024 0.21
0.008
ZCMU0702
44