COMPLETE INSTRUCTIONS G100-G300
73
5 . Set the new PIN code:
•
After entering the fourth digit switch off the panel.
•
Repeat the entry of the new code.
If the system verifies the correspondence between the code entered and the one
programmed, the code is stored; the storage is signalled by a 3 s flashing of the indicator
lights and the LED. Close the door at any time to exit from the procedure; the old PIN code
will remain stored in the system.
CAUTION!
In the event of theft or loss of the PIN CODE CARD contact your supplier.
19 - REPLACE OF THE BATTERY.
19.1 -
Flat battery in the radiocontrol device (G100) or Driver Card (G300).
If when one of the radiocontrol buttons is pressed the LED flashes for a short time or
in an irregular way this means that the battery is low. For a Driver Card, the flat
battery signal consists of 10 flashes of the LED installed in the vehicle.
If the system does not disarm in the presence of the Driver Card, press the button on
the dirver card. How to replace the battery.
1.
To change the battery, open the radio control / Driver Card shell, being careful to
lever it up at the point the area indicated in the drawing.
2.
Remove the battery by extracting it in the manner shown.
3.
Wait approximately 10 s.
4.
Insert the new battery, taking care to make sure your fingers touch it only on the
sides. Make sure its polarity is correct, as indicated in the diagram.
5.
Close the shell and press radiocontrol button “A” or the Driver Card button,
checking that the system responds correctly. Perform the test near the vehicle.
6.
Dispose of the empty battery in an appropriate disposal-bin.
7.
In the event of loss of both the remote controls or the Driver Cards an emergency
disarming may still be performed. Reference should be made to the disarming/
emergency procedure (page 72).
