COMPLETE INSTRUCTIONS G100-G300
69
To proceed onwards to the next table, turn the ignition key to OFF position then to ON. The
system will respond with three flashes of the arrows to indicate that you are in the basic
functions table; this signal will be emitted about every 10 s to remind you of the number
of the table in which you are located.The system will again confirm the change of table
by flashing the direction indicators. To move to next table turn the panel button to position
OFF and then ON.
The system always confirms the change of table by the flashing of the
indicator lights: the number of flashes corresponds to the number of the relative table.
15.4 - How to enable / disable a G300 function.
After accessing the basic or advanced functions table, quick-press the control panel
button and place yourself on the line number corresponding to the function you want to
enable / disable. Short flashes will indicated that the function is disabled, slow flashes
that it is enabled. The number of flashes will be the same as that of the line in the functions
table that you have selected. To enable / disable a function, keep the button on the control
panel pressed down until the frequency of the LED flashes change. Several functions on
the same page can be enabled at the same time. Enabling one function does not automatically
disable the others.
When you have finished, close the vehicle’s bonnet and the system will signal by flashing
the direction arrows for 3 s that you have exited the programming procedure. Beside the
tables, in which you will find the programmable functions subdivided into buzzer, basic
and advanced, the programming procedure is shown in diagram form; this will be useful
as a quick reminder when carrying out the various phases.
16 - PROCEDURE FOR ADDING NEW RADIOCONTROL DEVICES (G100) AND
NEW DRIVER CARDS (G300).
G100
16.1 - Procedure for adding new radiocontrol devices (self-learning).
If the radiocontrol devices are lost or are not operating properly, it is possible to replace
them but only under secure conditions as this operation is only allowed in particular
circumstances. If you still possess at least one of the radiocontrol devices and it is
operating correctly, proceed as follows:
1.
Disarm the system.
2.
Open a door and the bonnet.
3.
Turn on the ignition.
4.
Keep button “A” on the radiocontrol device pressed down until the direction
indicators flash.
5.
Key in the PIN code.
6.
The system will confirm that you have accessed the self - learning procedure by
other 5 flashes of the direction indicators and by lighting up the system LED with
a steady light.
7.
Press key “A” on the radiocontrol, checking that the radiocontrol LED flashes and
that the LED on the emergency panel stops shining for approximately 1 s; the
direction indicators will also give a short flash to confirm that the radiocontrol
device has been recorded in the system’s memory.
8.
Repeat step 7 for all the radiocontrol devices that you want to enable (the
