COMPLETE INSTRUCTIONS G100-G300
72
18 - EMERGENCY.
To disarm the system without using the radiocontrol device, proceed as follows:
press the button on the emergency panel for a number of times equal to the first figure
of your PIN code. For each press on the key, the LED will give a fast flash. A longer pause
will be interpreted by the system as meaning that you have finished entering a figure,
which will be signalled by the LED with a long flash. Proceed to enter all the other figures
in the code in the same manner. When all the figures have been entered, if thecode is
correct the system will disarm.
SIREN
ON
ALARM
SYSTEM
DISARMED
PIN CODE
OK
Press for a number of
times equal to the figure
in the PIN code
Enter next
PIN CODE
figure
Short
flash
Long
flash
pause
18.1 - PERSONALISING THE PIN CODE.
Since the PIN CODE represents a means of access to the system, it must not be left
unattended inside the vehicle. It could be used to disconnect the system or connect the
remote controls or Driver Cards without authorisation. The PIN code may be easily changed
as follows:
1 . Disconnect the system.
2 . Turn the control panel to position “panel on”.
3 . Open a door and the trunk and keep them open during programming.
G100
Press button “A” on the remote control until the indicator lights flash once
to signal entry into programming mode.
G300
Enter the full Pin Code. Entry into programming mode is signalled with
one flash of the indicator lights.
4. Enter the old PIN code;
the confirmation is made by 5 flashes of the direction indicators.
•
Press the button on the emergency panel a number of times corresponding to the
first digit of the PIN code to be entered. The LED flashes fast every time the button
is pressed.
•
A longer pause is interpreted by the system as the end of entering the first digit,
which is signalled by a long flash of the LED. Repeat this operation for all the other
digits.
