COMPLETE INSTRUCTIONS G100-G300
71
16.3 - Switching on / Switching off of Driver Card .
It is absolutely compulsory to switch OFF the Driver Card, as this is a radio device, when
you board on the plane.The same solution can be applied if the Driver Card is not used for
a long period of time (in this way you avoid the useless battery consume).
To switch ON again the Driver Card do the following:
•
shortly push the button on the Driver Card, until that the LED flashes every 3 s.
Instead, to switch OFF the Driver Card do the following:
•
keep the button pushed for a time approximately of 9 s.; during this time the LED of the
Driver Card will remain ON.
After these 9 s. the LED and the Driver Card will be switch OFF.
17 - ALARM RECORD.
When it is being disarmed, the system reports if there has been an alarm by four acoustic
and visual signals emitted by the direction indicators and buzzer. Pay attention to the LED
signals that remain available until the next time the system is armed or until the ignition is
turned on. The signals (number of flashes) identify the cause of the alarm.
LED SIGNALS
CAUSE OF THE ALARM
1 flash
doors/boot opened
ultrasonic volumetric sensor
triggered
3 flashes
bonnet opened
4 flashes
start -up attempts
(ignition key)
5 flashes
outside module disconnected
4310 siren disconnected
6 flashes
2 flashes
speed input sensor I addiotional
sensors triggered
satellite anti- theft disconnected
not used
Driver Card battery flat
7 flashes
8 flashes
9 flashes
10 flashes
