COBHAM Sailor 250 FleetBroadband, Training Manual, Page: 120 / 270

110
Chapter 4
Interfaces
4
Example:
Figure 4-20
Figure 4-21
Figure 4-22
4.6.1 Local exchange
If the local exchange is not used, the default behavior is such that
incoming calls will cause all connected phones to ring. If you want
to be able to call a specific phone connected to the terminal, you
must use the local exchange function. With this function enabled,
when you dial the mobile number of the terminal, a recorded
message guides you to dial the number for the local phone you
want to call. Your call is then transferred to the requested phone.
To set up the local exchange, do as follows:
Select
SETTINGS > Common > Local exchange from the left
navigation panel.
Type in the default number.
Incoming calls are transferred to this local number if the caller
dials * after calling the mobile number, or the caller dials nothing
after the recorded message.
Select the call types you want to direct to the local exchange.
For example, if you use 3.1 kHz Audio for a fax machine only, you
do not want to use the local exchange for 3.1 kHz Audio.
If no call type is selected, the local exchange function is disabled.
NOTE!
IP handset 0501
Rings on incoming standard
voice.
IP handset 0502
Rings on incoming standard
voice.
Incoming 3.1khz audio will not
make any of the ip handsets
ring.
Outgoing call will be standard
voice.
NOTE!
If Multi-voice is enabled, the
local exchange function is not
available.
Figure 4-23