COBHAM Sailor 250 FleetBroadband, Training Manual, Page: 118 / 270

108
Chapter 4
Interfaces
4
og mellemrum] The terminal has a built-in DHCP server which can
be used to dynamically assign IP addresses to devices connected
to the terminal.
(In above it is 192.168.0.9) Configure the new IP handset (All T&T
IP handset is default configured as 0501 – 0501
Using a browser enter the IP address for the new IP handset i.e.
192.168.0.9. This will open the WEB MMI for the IP handset.
Select SIP Settings
Click “edit” and change the User name to 0502 -> 0516
(The Users in the SIP server is predefined to 0501 – 0516)
Enter a password (in this case 0502)
Click “save” to save the entry.
Setting the call types for IP handsets
Select SETTINGS > IP handsets > Call settings .
For each handset, select the call types you want to enable for
incoming and outgoing calls.
Figure 4-17
For
Incoming calls
, you can select Standard or 3.1 kHz Audio
or both. If you select both, the handset will react (ring) on any
incoming call. If, for example, you select Standard, the handset
will only react on calls made to the Standard phone number.
For
Outgoing calls , you can select either Standard or 3.1 kHz
Audio. The selected type will be used by default, if possible, for
any outgoing call.
Setting up the IP handset compatibility
If you are connecting your Thrane IP Handset(s) to the terminal
through a separate router with NAT, you must use IP handsets with
software version 1.8 or newer and set up the handset compatibility
in the web interface of the terminal as described below.
To see the software version of your IP handset, select
MENU > Status > Software version in the IP handset .
To change the IP handset compatibility:
Select
Settings > IP handsets > Server settings .
Version 1.8 or newer
and use IP handsets with software version
1.8 or newer. If you are connecting your IP handset(s) directly to
the terminal or through a switch without NAT, select Version 1.7
or older. In this case you can use IP Handsets with any software
version.
Figure 4-18