Special Program Menu
Page 18
IQDM Service Tool Owner’s Manual
Speed Controller Cloning – Transferring Settings from the Vehicle to the IQDM
1. Locate a vehicle that has the desired speed controller settings.
2. Turn the key switch to the OFF position, place the Forward/Reverse handle in the NEUTRAL position,
and lock the park brake.
3. Plug the IQDM into the vehicle.
3.1. Connect one end of the cable to the jack located on the bottom of the IQDM unit.
3.2. Connect the adaptor to the IQDM cable.
3.3. Remove the sealed cap from the IQDM jack located on the vehicle below the Forward/Reverse
switch.
3.4. Align the keyed portion of the plug with the IQDM jack and connect the plug to the jack
(Figure 3)
.
4. Press and hold the MORE INFO button while pressing the PROGRAM button.
5. Press the SCROLL DISPLAY down button until the "Cont Settings
→
Prog" function is on the
top line
of
the display screen.
6. After pressing the MORE INFO button, a prompt will appear to confirm the operation
(Figure 13)
. To
abort the operation, press the CHANGE VALUE down button; otherwise, proceed to the next step.
7. Press the CHANGE VALUE up button to confirm the operation.
8. The IQDM will display a "working..." message for the next few seconds while the controller settings are
being stored in the IQDM’s memory
(Figure 14)
.
9. When the IQDM is finished recording the speed controller settings, a confirmation message is displayed
(Figure 15)
.
10. With the controller settings stored in the memory of the IQDM, the IQDM can be used to transfer all of
the desired speed controller settings to any IQ System vehicle or group of IQ System vehicles.
See
Speed Controller Cloning – Transferring Settings from the IQDM to the Vehicle on page 19.
Figure 13 Controller Settings Transfer to IQDM
Figure 14 IQDM Working
PROGRAM
MORE INFO
SCROLL
DISPLAY
CHANGE
VALUE
TEST
DIAGNOSTICS
PROGRAM
MORE INFO
SCROLL
DISPLAY
CHANGE
VALUE
TEST
DIAGNOSTICS
Summary of Contents for IQDM
Page 28: ......