General Information
Page 6
IQDM Service Tool Owner’s Manual
GENERAL INFORMATION
The IQDM handset, when connected to a vehicle, is powered entirely by the vehicle batteries through the
speed controller.
OVERVIEW
PLUGGING THE IQDM INTO THE VEHICLE
1. Connect one end of the cable to the jack located on the bottom of the IQDM unit.
2. Connect the adaptor to the IQDM cable.
3. Remove the sealed cap from the IQDM jack located on the vehicle below the Forward/Reverse switch.
4. Align the keyed portion of the plug with the IQDM jack and connect the plug to the jack
(Figure 3)
.
INTRODUCTORY DISPLAY
Immediately after the IQDM is connected to the vehicle, the screen displays a copyright notice and the IQDM
model number. After a few seconds, the screen displays the following information:
•
Speed controller model number
•
Date the speed controller was manufactured
•
Speed controller serial number
•
Speed controller software version
In the event that the IQDM does not display any information, or the screen is difficult to read, refer to the IQDM
troubleshooting procedures.
See IQDM Troubleshooting on page 22.
Figure 3 IQDM to Vehicle Connection
Summary of Contents for IQDM
Page 28: ......