www.directed.com
10
primary harness wiring guide
This guide describes in detail the connection of each wire. Also included are possible
applications of each wire. This system was designed with the ultimate in flexibility and
security in mind. Many of the wires have more than one possible function. Please read
the instructions carefully to ensure a thorough understanding of this unit and how it
operates.
h1/1 black ground
Connect the BLACK wire to a clean, paint-free sheet metal location (driver’s kick panel)
using a factory bolt that does NOT have any vehicle component grounds attached to
it. A screw should only be used in conjunction with a two-sided lock washer. Under
dash brackets and door sheet metal are not acceptable ground points. It is recom-
mended that all security components be grounded at the same location.
h1/2 and h1/11 brown speaker outputs
Connect the BROWN output wires to the BROWN wires of the 518C Neo Siren.
h1/3 gray (-) hood input zone 6
Connect this wire to the hood pin. If the hood is open when the alarm is armed, this
wire will trigger the siren. Use either this wire (preferred) or the wire from the
Intellistart module, but not both.
