Unit 1, 10 Duerdin St, Clayton VIC 3168, Australia
Tel: +61 3 9239 8088 Fax: +61 3 9239 8024
E-mail: [email protected] www.clenergy.com.au
10
page
of 25
Installation Instruction
5.1 Tile Interface Installation
5.1.1 Determine the positions of the Roof
Hooks according to your plans. Remove
the roof tiles at the marked positions or, if
possible, simply push them up slightly.
5.1.2 Fix the Roof Hooks to the rafter using
Buildex 14-10 x 50 (14 gauge, 6.3 mm, 10
TPI, 50 mm long) Hex Head Zips screw with
at least 35 mm embedment as shown in
the figure on the right following the Buildex
screws installation guide below:
- Use a 3/8" Hex Socket.
- Use a mains powered or cordless screw
driver with a drive speed of 3,000 RPM
maximum.
- Fit the driver bit into the screw and place
at the fastening position.
- Apply consistently firm pressure (end
load) to the screw driver until the screw is
fastened.
5.1.4 If necessary, use an angle grinder
to cut a recess in the tile covering the Roof Hook at the point where the Roof Hook extends so that
the tile lies flat on the surface. If grooved tiles are used, it will also be necessary to cut a recess in
the lower tile.
5.1.3 The roof hook must not press against
the roof tile. If necessary, shim the roof hook
with wood.
Incorrect
Correct
