Unit 1, 10 Duerdin St, Clayton VIC 3168, Australia
Tel: +61 3 9239 8088 Fax: +61 3 9239 8024
E-mail: [email protected] www.clenergy.com.au
23
page
of 25
Installation Instruction
Fix the Angle Bracket to the Isolator Shade
and then fix the assembled Isolator Shade
on the Rail as shown in the Figure on the
right.
Note: Allow space above the Rail for the
Isolator Shade Cover to open fully.
Recommended torque for M8 Bolts for
fixing Angle Bracket on Isolator Shade is
8-10N·m.
Recommended torque for M8 Bolt for
fixing Isolator Shade on the Rail is 16-
20N·m.
After cable installation, close the Isolator
Cover as shown in the Figure on the right.
5.5.2 Cable Clip Installation
- Click the top end of the Cable Clip into
the channel on the back of the rail.
- Push the other end of the clip in to the
rail channel, using a rubber mallet if
required.
