CleaverBrooks ProFire Q Series, Installation Operation & Maintenance

Page: 73 / 88

750-437
Q Series Full Modulation
6-15
Troubleshooting
95
Any # Error relay supervision
Check for voltage feeding back on the output given by the diagnostic code. Fix the wiring
error / defective component causing the voltage feedback and reset the fault.
3
External power supply NO contact
(ignition transformer - X4-02.3)
4
External power supply NO contact (fuel
valve 1 - X8-02.1)
5
External power supply NO contact (fuel
valve 2 - X7-01.3)
6
External power supply NO contact (pilot
valve - X7-02.3)
96
Any # Error relay supervision
Remove the wire from fan output terminal X3-05.1 and perform the following two tests:
1. With power connected to the LMV3 and the LMV3 in standby, ensure there is no voltage
on fan output X3-05.1.
2. With no power connected to the LMV3, ensure there is no continuity between fan output
X3-05.1 and neutral.
If either test fails, replace the LMV3. If both tests are passed, reset the fault.
3
Relay contacts have welded (ignition
transformer)
4 Relay contacts have welded (fuel valve 1)
5 Relay contacts have welded (fuel valve 2)
6 Relay contacts have welded (pilot valve)
97
Any # Error relay supervision
0
Safety relay contacts have welded or
external power supply fed to safety relay
98
Any # Error relay supervision
If the fault occurs continuously, replace the LMV3.
2
Relay does not pull in (safety valve - X6-
03.3)
3
Relay does not pull in (ignition
transformer - X4-02.3)
4
Relay does not pull in (fuel valve 1 - X8-
02.1)
5
Relay does not pull in (fuel valve 2 - X7-
01.3)
6
Relay does not pull in (pilot valve - X7-
02.3)
99
Any # Internal error relay control If the fault occurs continuously, replace the LMV3.
3 Internal error relay control
On software version V03.10, if this error occurs during standardization of the VSD,
temporarily deactivate the alarm in the case of start prevention (set parameter 210 = 0),
reset the fault, and re-standardize. Otherwise, if the fault occurs continuously, replace the
LMV3.
100 Any # Internal error relay control If the fault occurs continuously, replace the LMV3.
Error
Code Diag. Code Description
Corrective Action
Note: Diagnostic codes are additive. If a diagnostic code appears that is not on this list, it is a combination of multiple diagnostic codes.