CleaverBrooks ProFire Q Series, Installation Operation & Maintenance

Page: 83 / 88

Startup/Service Report
Startup/Service Report (required to validate warranty)
The following information should be filled in by the service technician at startup or after any adjustment to the burner. A copy of the startup report MUST be
forwarded to CB to validate burner warranty.
Registration
Startup Date:
Serial Number:
Burner Model:
LEGEND
“w.c. = inches water column (pressure)
MMBH = Million British Thermal Units Per Hour
Stack Temp (gross) = flue gas temperature inside stack
BURNER CHECKS
Electric Power (enter readings) Voltage Amperage
Burner motor/control circuit:
Combustion air : Air path to burner air-inlet is clear? (circle one) no yes
Burner room has adequate supply of fresh air? (circle one) no yes
Gas Train Leak Test: Train tested; corrective action taken if required (circle one) no/fail yes/passed
Test readings (enter values):
Test Conducted at Gas Firing Rate
Low 50% High
Firing Rate (MMBH)
Flame Signal Reading
Steam Pressure (PSIG)
Water Temperature °F
Room Temp °F
Stack Temp (gross) °F
O2%
CO2%
CO (PPM)
NOx (PPM)
Combustion Efficiency %
Stack-Draft pressure ("w.c.)
Furnace Pressure ("w.c.)
Blast Tube Pressure ("w.c.)
Gas Pressure at: regulator inlet ("w.c.)
regulator outlet ("w.c.)
burner manifold ("w.c.)
FUEL CURVE
LMV3 Fuel-Curve Settings (enter values): fuel-curve point Air Speed % Fuel angle (°)
P0 (ignition)
P1 (low fire)
P2
P3
P4
P5
P6
P7
P8
P9 (high fire)
CONTROL CHECK
Note: certain devices may not be applicable Test Set Point
Heat Exchanger: Low Water Cutoff (LWCO)
Auxiliary Low Water Cutoff (ALWCO)
High Water Cutoff (HWCO)
Operating (cut in & cut off) Limit control
Operating (modulation) Control
High Limit
Burner: Combustion Air Switch
Flame Failure
Gas Train: High-gas pressure switch
Low-gas pressure switch
Proof-of closure switch
SIGN OFF
Printed Name Signature Date
Commissioned by:
End User - Accepted by: