23
Replacing the Fuses
1.
Turn off the main power switch at the rear of Power Supply and detach the power
cord.
2.
Open the fuses compartment located inside the Power Entry Module by inserting
a small flat blade screwdriver into the slot above the ON/OFF switch. Turn the
screwdriver to gently pry open the fuses compartment.
Note: The fuses compartment will not open with the power cord in place.
3.
Pull the fuses holder out of the compartment and inspect the fuses. If the fuses
are burned or there is a break in the fuses element, replace the fuses with identical
type of fuses.
4.
Place the fuses holder back into the compartment.
5.
Snap the cover closed.
For additional fuses, contact Cleaver Scientific
Maintenance
PowerPro Series Power Supply uses all solid-state components and should require no
maintenance or recalibration under normal use. If the unit must be returned for repair,
contact our SERVICE DEPARTMENT or your local distributor for shipping instruction.
Section 6
Ordering Information
Cat. No.
Description
PowerPro300
300V, 700mA, 150W Power Supply
PowerPro3AMP
300V, 3000mA, 300W Power Supply
PowerPro500
500V, 800mA, 300W Power Supply
