CLAS PE 6001, Manual

Page: 17 / 32

PE 6001
DOUBLE SCISSOR LIFT 3T
ANCHOR PLUG INSTALLATION:
The anchor plugs installation must be carried out simultaneously whit the installation of the lift,
this is to ensure the stability of the structure and a perfect seal:
Leveling:
Lift loading test:
Picture 21
Picture 22
Adjust the base parallelism and the distance between the two platforms.
Fasten the anchor plugs with a percussion electric drill, poke a 120 mm hole and clean it
before inserting the dowels. (Picture21)
Use a rubber hammer to insert the dowels into the floor.
Use a level to adjust the leveling of the bases.
If the irregularity of the platforms is due to the irregularity of the bases, use an iron thickness
to level it.
After adjusting the level, insert the anchor and use a hammer to secure it.
Switch one the machine with the «MAIN SWITCH» power button.
Press the “UP” button, and pay attention to the synchronization and to the lifting fluidity.
Check that there is no leakage of oil.3
The gap between the base plate and the ground after the adjustment has to be filled with
an iron or concrete plate.
During the test of the lift, no person, object and or material must be located near the two sides
and below the lift. If an anomaly occurs, press the “EMERGENCY STOP” button to stop the lift
immediately. After removing the obstacles repeat the test.