CLAS OH 1301, Manual

Page: 20 / 28

OH 1301
LIFTING TABLE FOR EV/HYBRID BATTERIES AND HEAVY
COMPONENTS
Platform sliding extension feature
When the lift is to be used as a stationary work surface, the sliding platform extension may be
used to facilitate the separation of powertrain components (i.e., engine and transmission). Retract
spring plunger and pull on Table Handle (See Figure 3) to extend sliding platform. Release spring
plunger and slide platform extension until it locks into a stationary position.
Secure components to the platform with bolts and/or straps. Many M10 x 1.5 holes are provided in
the platform top to thread bolts into.
CAUTION: To prevent damaging threads in the platform, do not torque bolts beyond 50 ft. lbs. (68
N•m). Holes in the side edges of the platform are provided for securing straps.
WARNING: To prevent personal injury and/or equipment damage,
• Always secure components to the platform with bolts and/or straps.
• Do not raise or lower lift with platform extended.
• Do not use the Platform Handle (located on the sliding platform) to move the entire
lift.
Operating The Lift To Remove Components
1. Always follow the vehicle manufacturer’s recommended service procedure for removal of the
component.
2. Position the lift under the vehicle. Connect the air hose to the air pump.
3. Press the end of air pump foot pedal marked to raise the lift to the load.
4. Remove any remaining bolts from the vehicle component.
Figure 3
Leveler
screw
Platerform
handle
M10 x 1.5 holes
to secure
components
Spring plunger