OH 1301
LIFTING TABLE FOR EV/HYBRID BATTERIES AND HEAVY
COMPONENTS
Unpackaging
1. Cut shipping banding from carton and platform.
2. Install lift handle into base frame weldment and secure in place with cotterless hitch pins.
3. Remove the wood chocks from around the caster wheels.
4. Carefully roll the lift off the shipping pallet onto the fl oor.
Prepare The Air Pump For Operation
Pictogram Defi nitions
Activating the pump with the pedal end marked with this pictogram, the fl ow
of fl uids is directed out of the reservoir.
Activating the pump with the pedal end marked with this pictogram, the fl ow
of fl uids is directed back to the reservoir.
Cut shipping tie straps from air pump.
Air Supply Hook Up
1. Remove the thread protector from the air inlet of the pump. The pump’s air inlet with quick
coupling on one side and on the other side the internal threads M1/4G is fi xed on the pump. Select
and install the threaded fi ttings which are compatible with your air supply fi ttings. The air supply
should be 600lt/min at 100 PSI (7 BAR) at the pump to obtain the rated hydraulic pressure. Air
pressure should be regulated to between 50 PSI (3.5 BAR) and 140 PSI (9.5 BAR). A pressure of
100 PSI (7 BAR) is the recommended minimum. Secure your pump fi tting to the air supply.
2. It is highly recommended to install an automatic air line oiler to the air supply as close to the
pump as possible. Set the unit to feed approximately one drop of oil per minute into the system.
Use SAE grade oil, ISO22
Priming The Pump Unit
Under certain circumstances it may be necessary to prime the air pump. To accomplish this,
perform the following procedure:
1. Press the release end of the pedal while holding down the air intake valve with a fl athead
screwdriver. The air intake valve is located directly under the pedal in the area marked . The valve
is depressed simultaneously with the area of the pedal during priming.
2. Allow the pump to cycle approximately 15 seconds.
3. Remove the screwdriver and press the end of the pedal once more.
4. If the cylinder extends or pressure builds, the pump has been successfully primed. If the pump
does not respond, repeat the procedure, jogging the air intake valve while holding the pedal in the
position
PREPARATION
Summary of Contents for OH 1301
