CLAS OH 1301, Manual

Page: 18 / 28

OH 1301
LIFTING TABLE FOR EV/HYBRID BATTERIES AND HEAVY
COMPONENTS
Entrée d’air (1/4-18 NP interne)
Image 1
Functional check of lift
Without external load applied to lift platform, fully raise and lower multiple times to ensure proper
function of the hydraulic system and scissor components.
1. Press the end of the air pump foot pedal marked to raise the lift platform until it stops at
maximum extension.
2. Press and hold the end of the air pump foot pedal marked to lower the lift platform until it
reaches full collapse.
3. Ensure platform raises and lowers only when the air pump foot pedal is actively depressed by
the operator.
WARNING: To prevent personal injury and/or equipment damage, if platform moves after air pump
pedal is released, discontinue use and service immediately.
Preparation of other features
A. Platform Tilting Features
1. Turn forcing screws in/out fully to ensure proper function of platform tilting feature. See Figure
1 of “Fine Adjustment Tilting Feature” section.
B. Stabilization Feature
1. Insert leveler screws into sockets (approx. 5 turns). Leveler screws should not project above
steel tube or contact platform underside when not in use. See Figure 2 of “Stabilization Feature”
section.
C. Platform Sliding Extension Feature
1. Cut shipping banding securing platform halves
2. Retract spring plunger and extend platform by pulling on table handle. Ensure spring plunger
engages at all three stop positions when the plunger is released.
Filler/ Vent Cap
Air itake valve