1
1
1
1
1
1
If the receiving remote control does not want
to receive the code, press the button
on the original remote control a little bit
longer.
7. Repeat steps -6 to programme additional
functions.
When the programming is done, press the
button for desired device (the same as in
step 1). The LED light flashes twice before
it is turned off and the remote control is
ready to use.
Observe!
On some VCRs and DVD players
the buttons up and down, left, right and ok
can be used for play, stop, fwd, rew and rec.
Tip!
By using the SHIFT button when recor-
ding, access to another pages with button
functions is given. During recording, press
[ SHIFT ]
once to activate the 4th page.
Press
[ PAGE ]
to switch to the th and the
6th page. Press
[ SHIFT ]
again to leave the
“SHIFT mode.”
advanced recording of functions from
other remote controls
If recorded functions only work once in a
while, the original remote control contains
double signals. If this happens, follow the
instructions below.
1. Press the button for desired device, for
example
[ TV ]
. The LED light flashes once.
. Press the buttons
[ P+ ]
and
[ VOL- ]
simultaneously for seconds until the LED
light is lit.
. Enter the registration code
“0000”
. The
LED light continues to shine with a steady
light.
4. Point the original remote control towards
the infrared eye on the universal remote
control at a distance of about -8 cm.
Put the remote controls on a flat surface
to get good contact between the remote
controls. Also makes sure that both remote
controls have fresh batteries.
E
N
G
LI
S
H
