10
10
11
11
11
11
Recording functions from other
remote controls
If some functions from the original remote
control are missing on this URC, you can
“teach” the remote control these functions
from the remote control.
In addition to controlling pre-programmed
devices, this URC can also control for
example HiFi equipment. The remote control
can be taught a total of 6 commands.
1. Press the button for the desired device,
for example
[ TV ]
. The LED light flashes
once.
. Press the buttons
[ P+ ]
and
[ VOL- ]
simultaneously for seconds until the
LED light is lit.
. Enter the registration code
“0000”
. The
LED light continues to shine with a steady
light.
4. Point the original remote control towards
the infrared eye on the universal remote
control at a distance of about -8 cm.
Put the remote controls on a flat surface
to get good contact between the remote
controls. Also make sure to have fresh
batteries in both remote controls.
. Press shortly on the button you want to
program on the universal remote control,
for example
[ 1 ]
for channel 1.
If no button has been chosen within 8
seconds, the LED light flashes quickly 6
times and the programming is cancelled.
6. Press briefly on the corresponding button
on the original remote control (in this
example Channel 1). The LED light
flashes and then returns to a steady light.
If the LED light flashes quickly 6 times,
the programming has failed. Adjust the
remote controls’ position in relationship
to each other and try again according to
steps and 6.
E
N
G
LI
S
H
