11
English
23
24
25
31
26
29
30
28
27
Remote control
23. [ Menu ]
24. [
▲
Cancel ] Advance to desired submenu,
move up, undo
25. [ OK ] Open display mode, confirm selection
26. [
◄
1
] Advance to desired setting in submenu.
Press the required number of times to enter
the following characters: 1. / : @ _
27. [
▼
2 abc ] Advance to desired submenu,
move down
28. [
►
3 def ] Advance to desired setting in submenu
29. [ 4–0 ] Numerical and letter buttons. Press
0
several
times to enter + and -
30. [ ] Activate laser pointer when positioning camera
31. [ # ]
Note:
• The remote control is stored on the inside of the lid (1).
• Certain symbols on the remote control may not be applicable to this camera
model.
• The maximum range of the remote control is approximately 9 m. Direct sunlight on
the camera or remote control might shorten the range.
• When the camera is switched on (in either
ON
or
TEST
mode) it needs 10–30 seconds
to initialise and connect to the telephone network.
• The strip of plastic protruding from the battery holder must be removed. The strip
of plastic prevents the batteries from discharging during storage and transport.
If the remote control does not work, the battery may be flat.
Procedure for changing:
1. Pull out the remote control battery holder by sliding the snap lock towards
the battery holder at the same time as you pull the battery holder out.
2. Insert a new battery (1 × CR 2025), the positive terminal of the battery (+) should
be facing you. See the sticker on the remote control.
3. Insert the battery holder, making sure that the snap lock locks properly.
