19
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
MAINTENANCE
For maximum performance, it is essential that the drill press is properly
maintained. Always inspect it before use. Any damage should be repaired,
and faults rectified. Always unplug from the power supply before carrying out
any adjustment, servicing or maintenance.
Please refer to the Troubleshooting chart on page 20. If you are unable to
rectify any faults, please contact your local dealer or Clarke International for
assistance.
MONTHLY (IF IN CONSTANT USE)
1. Check the tightness of mounting bolts and head and column securing set
screws.
2. Check the drive belts for wear, and replace if frayed or damaged.
3. Use compressed air or a vacuum cleaner to remove any dust that may
have accumulated in the motor vents.
4. Apply a thin coat of wax paste or light oil to the table and column for
lubrication and to help prevent corrosion.
If the power cable is damaged in any way it should be replaced immediately.
LUBRICATION
All bearings are packed with grease
at the factory and require no further
lubrication.
Occasionally lubricate the quill shaft
assembly with light oil if required.
AFTER USE
Remove all swarf from the drill press
and thoroughly clean all surfaces.
Components should be kept dry, with
machined surfaces lightly oiled.
Always remove drill bits and store in a safe place.
Summary of Contents for 6505532
Page 28: ......
