9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
UNPACKING
This manual covers the CDP202B, CDP302B and 452B which are bench
mounted machines with either a wet T-slot table or round engineers table, and
the CDP352F and CDP452F which are the equivalent units with a tall column
for free-standing floor mounting.
The drill press is delivered with the components shown on page 8. Check the
parts against the list. Should there be any deficiencies or damage, you should
contact your CLARKE dealer immediately where the product was originally
purchased. Do not discard the packaging until the drill press is assembled. The
packaging consists of cardboard and appropriately marked materials which
can be sent to a re-cycling facility.
To protect the drill press parts from moisture, a protective coating of light
machine oil will have been applied to the outside surfaces. Remove any
excess with a paper towel.
Take care when lifting the head assembly, considering its weight.
ASSEMBLY
Before use, the drill press must be mounted and securely bolted to a strong,
heavy workbench, (CDP202B and CDP302B models) of sufficient height that
you will be standing upright when working.
Likewise, the CDP352F and CDP452F should be bolted to the floor to ensure
stability.
COLUMN TO BASE
1. Bolt the column to the base with
the four bolts and washers
provided.
2. Add the column tube to the lower
column & secure with set screws
(CDP352F and CDP452F floor
mounted models only).
NOTE:
Ideally, the base, with
column attached, should be
firmly bolted to the
workbench or floor, prior to adding the other components.
Summary of Contents for 6505532
Page 28: ......
