13
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
NOTE:
If the belt slips whilst drilling, increase the belt tension.
CHECKING THE OPERATION OF THE MICROSWITCH
When closing the cover, check the operation of the micro-switch. It is
important that it operates as soon as the cover is opened in order to prevent
the drill press from operating whilst the cover is open. If necessary, adjust the
position of the switch actuating tab shown in Fig 11, to ensure correct
operation.
SETTINGS AND ADJUSTMENTS
TABLE
The table may be raised, lowered or
swivelled around the column, after
slackening the table support locking
handle shown in Fig 12 and adjusting
the table position accordingly.
Retighten the handle before starting
work.
It may also be tilted by loosening the
bolt which secures the table to its
mounting, tilting the table to the
required position and retightening
the bolt shown in Fig 13.
A 24mm socket and ratchet spanner
will be required.
The table can also be rotated after
releasing the locking handle below
the table pivot.
A bevel scale is provided on the
table mounting, (measured in
degrees), to assist in setting the
required angle. However, for greater
accuracy the use of a protractor is
recommended.
For all normal operations, the table
should be set to 0°.
To check to ensure the drill is
perpendicular to the table, install a
Summary of Contents for 6505532
Page 28: ......
