13
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
3. Move the cutting head more slowly for thicker and harder metals and keep
the cutting head moving while cutting.
4. If clean cutting is not achieved, adjust the control potentiometer knob to a
higher level and/or increase air flow.
CUTTING TABLE
FOR EDGE STARTS
Hold the torch perpendicular to the
workpiece with the front of the tip on
the edge of the workpiece at the
point where the cut is to start.
FOR DRAG CUTS
Keep the torch in contact with the
workpiece.
5. Cut at a steady speed without
pausing. Maintain the cutting
speed so that the arc is about 30°
behind the direction of travel.
6. Keep the torch in light contact
with the workpiece to avoid
nuisance shut off of the torch.
PIERCING WITH THE TORCH
NOTE: The recommended maximum
cutting capability from an edge is 2mm. If you need to cut sheet metal more
than 2mm without an edge start, make a hole ø 6mm using an electric drill
before you start cutting.
Thickness
Steel
Aluminium
0.8mm
10A clean cutting
1mm
12A clean cutting
16A clean cutting
2mm
15A clean cutting
20A clean cutting
3mm
20A clean cutting
25A clean cutting
4mm
25A clean cutting
25A severance cutting
5mm
20A severance cutting
6mm
25A severance cutting
Summary of Contents for 6015700
Page 24: ......
