11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
PREPARATION FOR USE
1. Connect the power supply cable
to a mains socket.
2. Connect the earthing cable into
the machine (push in and twist).
3. Connect the two screw-in
connections to the cutting torch.
4. Connect the compressed air
supply to the filter/regulator.
•
An adaptor is supplied to receive
a length of hose.
5. Turn the air supply ‘ON’.
6. Pull up the air regulator knob and
turn it anticlockwise until a
pressure of 0.3 - 03.5Mpa is
displayed on the gauge.
7. When the pressure is set, push the
knob down to lock it at that
setting.
8. Fasten the earth clamp to the
workpiece. If a metal bench is
being used, make sure it has also
been connected to earth. Clamp
as close as possible to the
workpiece and take care not to
damage the cable while cutting.
•
If the surface of the workpiece is
painted or rusty, clean the surface
so that satisfactory contact
between the workpiece and the
earth clamp can be obtained.
Summary of Contents for 6015700
Page 24: ......
