Zip HydroTap® G4 BC100/75
28
EN
5. Using the Tap
Natural traces
The activated carbon contained in the filter is subject to natural fluctuations. By e.g.
vibrations during transport can result in slight abrasion of small coal particles. These
particles are harmless to health. If you see particles in the water, follow the instructions
in chapter 6 ”Filter Replacement” sub point 7.
Long period of non-use
Note: In ambient / warm water germs can multiply faster. Therefore, leave your
drinking water system switched on even during long periods of non-use.
If you still want to shut down your drinking water system for an extended period of
time, proceed as follows:
1. Turn off the water supply.
2. Tap chilled and hot water until no more water flows to empty the system.
3. Switch off the appliance and disconnect it from power supply.
After prolonged non-use
1. Reconnect the water supply. Pay attention to any leaks.
2. Reconnect the appliance to the power supply and switch it on.
3. After non-use for several days drain the first water out of the appliance:
• Chilled water: at least 4 litres
• Hot water: As soon as the red LED lights up continuously, drain hot water. Repeat
the process until the LED flashes again.
If necessary collect the water in a suitable container.
Attention! There is a scalding danger at hot water!
4. The appliance is now ready for use.
Note: If the system is not used for more than two months, the internal filter must
be replaced even if the change interval has not been reached!
