clage FX Next, Operating And Installation Instructions

Page: 38 / 208

28
EN
Problem Cause Solution
Display: “No device connected”
and appliance does not response
to the remote control
Remote control is not registered at the
instantaneous water heater
Register again, remove and insert the batteries again
Transmission range exceeded Place the remote control closer to the appliance, press button
Power failure Check the power supply of the instantaneous water heater
Symbol “battery” lights Flat batteries Insert two new type AA-batteries
Temperature changes uninten-
tional
Operation via other remote control, Smart
Control app or directly on the water heater
Only register the desired remote control
Sensor keys do not respond
Key lock active Press and hold left and right sensor key
Software has detected an error Reinsert batterys
The following table will help you to determine and rectify the reasons for possible problems .
8. Trouble-shooting and service
If you cannot rectify the fault with the aid of this table, please contact
the after sales service
We can either give you the name and address of an authorised customer
service company or repair the heater ourselves . In the latter case, please
send in the heater (at your cost and risk) with details of the problem and
a copy of the sales invoice .
CLAGE GmbH
After-Sales Service
Pirolweg 1 – 5
21337 Lüneburg
Germany
Phone:
+49 4131 8901-40
Fax: +49 4131 8901-41
Email: service@clage .de