Clack Water Specialist WS1TC, Operation And Instruction Manual

Page: 11 / 48

WS1TC & WS1.25 TC Manual Page 11
Mixing Valve
The mixing valve is installed on the outlet side of the control valve. The mixing valve is used to blend raw water with treated water.
To adjust the blended water, close the mixing valve. Open a water faucet to the desired fl ow rate. Open the mixing valve until the
desired hardness is reached. Close the faucet.
Installation Fitting Assemblies
The installation fi ttings are used to connect the optional bypass or the control valve to the plumbing system. There are eight
installation fi tting assemblies available:
1. 1” NPT elbow assembly
2. ¾” & 1” PVC solvent weld elbow fi tting assembly
3. 1” straight brass sweat fi tting assembly
3
4. ¾” straight brass sweat fi tting assembly
3
5. 1” plastic male NPT fi tting assembly
6. 1 1/4” plastic male NPT fi tting assembly
7. 1” plastic male BSPT fi tting assembly
8. 1 1/4” plastic male BSPT fi tting assembly
Both elbow fi ttings have a unique drill out feature to allow a ¼” NPT connection to the inlet and/or outlet which can be used for a
RO feed, test ports, pressure tap ports, etc.
The installation fi tting assemblies are sold in pairs and consist of two fi ttings, two nuts, two split rings and two o-rings. The
installation fi tting assemblies and the bypass valve are sold separately from the control valve.
3
Has not been tested for compliance with California Proposition 65, so this fi tting should not be installed in California.