Page 38
WS1TC & WS1.25 TC Manual
Replace the motor if necessary. Do not lubricate the motor or the gears. To reinstall the motor, move the spring clip loop to the
right and hold. Gently turn the motor while inserting so that the gear on the motor meshes with the gears under the drive gear cover.
Release the spring clip loop and continue to rotate the motor until the wires are horizontal and the motor housing engages the small
plastic bulge inside the drive bracket motor retainer. Reconnect the motor plug to the two-pronged jack on the lower left hand side
of the PC board. If the motor will not easily engage with the drive gears when reinstalling, lift and slightly rotate the motor before
reinserting. Reconnect the power plug.
Replace the valve cover. After completing any valve maintenance, press and hold SET HOUR and DOWN buttons for 3 seconds or
unplug power source jack (black wire) from the circuit board and plug back in. This resets the electronics and establishes the service
piston position.
Drive Cap Assembly, Main Piston and Regenerant Piston
The drive assembly must be removed to access the drive cap assembly. The drive cap assembly must be removed to access the
piston(s). The drive cap assembly is threaded into the control valve body and seals with an o-ring. To remove the drive cap assembly
use the special plastic wrench or insert a ¼
”
to ½
”
fl at blade screwdriver into one of the slots around the top 2
”
of the drive cap
assembly so it engages the notches molded into the drive back plate around the top 2
”
of the piston cavity. See Figure 5. The notches
are visible through the holes. Lever the screwdriver so the drive cap assembly turns counter clockwise. Once loosened unscrew the
drive cap assembly by hand and pull straight out.
The drive cap assembly contains the drive cap, the main drive gear, drive cap spline, piston rod and various other parts that should
not be dissembled in the fi eld. The only replaceable part on the drive cap assembly is the o-ring. Attached to the drive cap assembly
is the main piston and, if a regenerant is used, a regenerant piston.
Figure 5
Summary of Contents for Water Specialist WS1TC
