2
,--____J__i_____l..L_ _____
.____,,.cr:::'--i--------------,-1----,-' /.C::',--,--J
203356
BASIC SETTINGS FOR THE DRIVES
Adjusting the drives to the markings
1 . Check the position of the needle to the piston and
if necessary adjust (see »checking the position of
the needle to the piston«).
2. Set the baling ram to the front dead centre, so
that the crank arms and the piston bars lie parallel
ne
x
t to each other. The hole (B) on the left crank
arm pivot must then be on a level with the cap
nut (1-1).
In this position all the markings on the
corresponding drives must align with each
other and align with the shafts.
(Fig. 1 and 2)
QUADRANT 2 2 00 / 2 2 00 RC
2
203357
Basic settings for the drives
1
1.6 / 1
